CASO DESIGN Espresso Gourmet Latte Manual Del Usuario página 34

DE
5 Operation and Handing
EN
FR This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
ES
WARNING
NL

Caution hot steam can escape at device. Risk of burns.

Do not leave the device unsupervised when it is in operation, so that you can inter-
RU
vene quickly in the event of dangers.

PT
Always insert the portafi lter before you use the appliance.

Do not fi ll hot water into the watertank.
TR

The milk nozzle emits hot milk when in use. Do not touch the nozzle.

Never reach under the outlet openings of the portafi lter or the milk nozzle when the
SE
appliance is in operation.
PLEASE NOTE

If the water tank is empty when you start the brewing process, then the ON/OFF
button will light up white; the other buttons will fl ash green and the
on the control panel will start to fl ash. Fill the water tank with water and press the
"Espresso" button. The appliance pipes will fi ll with water and the appliance will
heat up again. Repeat your desired brewing process.

The appliance will automatically turn to standby mode after approx. 15 minutes.

Empty the drip tray regularly and/or when you see the red fl oat protruding out of
the opening in the drip grid.
5.1 Before fi rst use
Clean the appliance and accessories as described in the "Cleaning and care" section.
You should also carry out a brewing process without coff ee grounds as part of the clea-
ning process.
1.
Insert the drip grid in such a way that the red fl oat can protrude out of the opening
in the drip grid.
2.
Remove the water tank and fi ll it with water up to the "MAX" mark. Replace the
water tank into the appliance.
3.
Push the milk tank base onto the right side of the appliance until you hear it click
into place.
4.
Fill the milk tank with water up to the "MAX" mark. Place the milk tank lid on the
tank. Push the milk tank lock to the -symbol, place the milk tank on the base and
push the milk tank lock to the -symbol.
5.
Place the portafi lter (with an empty portafi lter basket) on the appliance's group head,
align the portafi lter to the "
" " position. When doing so, hold onto the side of the appliance or the water tank.
6. Place a large cup on the drip grid.
7.
Turn the milk nozzle control knob until the milk nozzle is pointed at the cup.
8.
Plug the appliance into the power socket and press the "ON/OFF" button.
9.
The appliance will begin to heat up. The buttons will fl ash white one after another.
10. The appliance will be heated up and ready to use as soon as all the buttons are
lit up and the control panel shows a temperature of 94 °C. This procedure takes
approx. 2 minutes.
34 CASO Espresso Gourmet Latte
" mark and then turn it anti-clockwise to the
-symbol