Decommissioning The Product - SMA GRID-CONNECT-BOX 12 Instrucciones De Funcionamiento

SMA Solar Technology AG

11 Decommissioning the Product

Danger to life due to electric shock when live components or cables are touched
High voltages are present in the conductive components or cables of the product. Touching live parts and cables
results in death or lethal injuries due to electric shock.
• Do not touch non-insulated parts or cables.
• Disconnect the product from voltage sources and make sure it cannot be reconnected before working on the
device.
• Only disassemble the protective covers, if the product is disconnected from all voltage sources.
• Wear suitable personal protective equipment for all work on the product.
Procedure:
1. Make sure that the product and entire multicluster system have been disconnected from all voltage sources.
2. Remove all fastening screws from the kick plates at the front and rear (TX 30). Retain the kick plates and the
fastening screws for later use.
3. Disassemble the protective covers and base plates.
4. Remove all cables from the product.
5. Release and remove the fastening screws on the bottom of the product.
6. Mount the protective covers and base plates.
7. Close the cabinet doors.
8.
Danger of crushing if raised or suspended loads tip over or fall
Vibrations or careless or hasty lifting and transportation may cause the product to tip over or fall. This can result
in death or serious injury.
• Always transport the product as close to the floor as possible.
• All means of transport and auxiliary equipment used must be designed for the weight of the product.
Weight: 109 kg.
• Always transport and lift the product upright.
• Always maintain a sufficient safety distance from the product during transport.
• Take into account the center of gravity of the product. The center of gravity of the product is
approximately in the center of the cabinet and is marked on the packaging with the center of gravity
symbol.
9. Remount the kick plates on the product.
10. Dispose of the product in accordance with the locally applicable disposal regulations for electronic waste.
Operating manual
DANGER
WARNING
GRID-BOX-12-3-20-BE-xx-12
11 Decommissioning the Product
31