Publicidad
Idiomas disponibles
Idiomas disponibles
Setup
Adjustments
1
Connecting
your monitor
to your computer
Navigating
the
menu
1 Press the center of the joystick to display the main
menu.
V_deo s_gnal Cable
to HDt5
of the
of the
monlior
connecting
compuler
Connecting
to a Macintosh
or compatible
computer
When connecling this monitor to a Macinlosh computer, use the
Macintosh adapler (not supplied) if necessary. Connect the
Macintosh adapler to/he computer before connec/ing the cable.
The pin assignment of the HD 15 video signal cable
Mainmenu
l,SRffl i
il_T'---
E<,r
I
i
i!!!!:_i!i!i@_t_ii!i;i!i;!:;i;iiii!ii_ii!i_i!!!!ii!iii!i!i
ii;_!!i_ii!iiil;i!i_il
[]
COLOR
CONVERGENCE
SO LANGUAGE
=..
a OPt'ON
the horizontal
the resolutionof the current
inputsignal (onlyif the signal
and
vertical
matchesto one of the
frequencies
recommended VESA
timing
of the current
modes),
inputsignal
2 Move the joystick
,I,/{ =to highlight the main menu that
you want to adjust and press the center of the joystick.
Pin No,
Signal
Pin No.
Signal
l
Red
9
DDC HOST
5V*
2
Green (Sync on
I0
Ground
Green)
I I
ID (Ground)
3
Blue
Bi-Direcdonal
12
4
ID (Ground)
Data (SDA)*
5
DDC
Ground*
13
H. Sync
6
Red Ground
14
V. Sync
7
Green
Ground
15
Data Clock
8
Blue Ground
(SCL)*
* DDC
(Display
Data Channel)
is a standard
of VESA.
2
Turning
on the monitor
and computer
1 Connect the power cord to the monitor and press the
(power) switch to turn on the monitor.
2 Turn on the computer.
No need
for specific
drivers
This monitor
complies
with the "DDC"
Plug & Play standard
and
automatically
detects
all the monitor's
information.
No specific
drive_
needs
to be installed
to the computer.
The first time you turn on your PC after connecting
the monitor,
the setup
Wizard
may appear
on the screen.
In this case, follow
the on-screen
instructions.
The Plug & Play monitor
is automatically
selected
so that you
can use this monitor.
Sub menu
o
{}
mU
Mlil_l
3 Move the joystick €/'1=to highlight the submenu that
you want to adjust. Then move the joystick <ii/,,_ to
make adjustments.
Adjusting
the brightness
and contrast
Brightness
and contrast
adjustments
are made using a separate
BRIGHTNESS/CONTRAST
menu. These adjustments
are
effective
for all input signals.
1 Move the joystick in any direction to display the
BRIGHTNESS/CONTRAST
menu.
2 Move the joystick
_/€ to adjust the brightness (-_-),
and <1--/,=1_ to adjust the contrast (¢).
====._
E
E
I_1
26
0
_
26
[]
Notes
• Do not touch the pins of the video signal cable connector.
• Check the alignment of the HDI 5 connector to prevent bending the pins
of tl_e video signal cable connector.
Note
If you set the brightness and contrast level to "0", the picture will black out
and no picture will appear.
Publicidad
