Publicidad
Idiomas disponibles
Idiomas disponibles
•
Color
is not uniform
• Degauss the monitor.*
If you place equipment
that generates
a
magnetic field, such as a speaker, near the monitor, or if you change
the direction the monitor faces, color may lose uniformity.
• White does not look white
• Adjust the color temperature.
• Monitor buttons do not operate (On appears on the
screen)
• If the control lock is set to ON, set it to OFF'.
• Letters and lines show red or blue shadows at the
edges
• Adjust the convergence.
•
A hum is heard right
after the power
is turned
on
• This is the sound of the auto-degauss
cycle. When 1he power is
turned on, the monitor
is automatically
degaussed
for five seconds.
* if a second degauss cycle is needed, allow a minimum interval of
20 minutes for the best result. A humming noise may be heard, but this is
not a malfunction.
On-screen
messages
If "OUT
OF SCAN
RANGE"
appears:
This indicates
that the input signal is not supporled
by the monitor's
specifications.
Refer to the following
remedies.
• Check
that the video frequency
range is within that specified
for
the monitor.
If you replaced
an old monitor
with this monitor,
reconnect
the old monitor
and adjust the frequency
range Io the
following.
FOR A240
Horizontal:
30 - 70 kHz; Vertical:
48 - 120 Hz
FOR A440
Horizontal:
30 - 96 kHz; Vertical:
48 - 170 Hz
If "NO
INPUT
SIGNAL"
appears:
This indicates
that no input signal is present.
Refer to the following
remedies.
• Check
that the video signal cable is properly
connecled
and all
plugs are firmly seated
in their sockets.
• Check that the HD15 video input connector's
pins are not bent or
pushed
in.
• Check
that the computer's
power is "on."
• Check
that the graphic
board is complelely
seated
in the proper
bus slot.
_!] If "MONITOR IS IN POWER SAVE MODE"
appears:
This indicates
that the computer
is in power
saving
mode, This
message
is displayed
only when your compuler
is in a power saving
mode and you press any one of the buttons on the monitor.
Refer Io
the following
remedies.
• Try pressing
any key on the computer
keyboard or moving the
mouse.
• Check
that the computer's
power is "on."
• Check
that the graphic
board is complelely
seated
in the proper
bus slot.
To display
this monitor's
name, serial number,
and
date of manufacture.
While the monitor is receiving a video signal, press and hold the
Joystick for more than five seconds to display this monitor's
information box.
MODEL:HMD_A240
MODEL:HMD*A440
i
SER
N0:t234567
SER
N0:1234567
MA"UFACTUREO:2002:_2
MA"UFACTUREO:2O02_2
Publicidad
