Publicidad
Idiomas disponibles
Idiomas disponibles
AXOVIA MULTIPRO 3S
1.4
Risk prevention - hinged gate drive for
residential use
WARNING
Ensure that any danger zones (crushing, cut-
ting, trapping) between the driven section and
the surrounding fixed sections created by the
opening of the driven section are prevented,
or indicated on the installation.
Permanently affix the crushing warning labels near
any fixed control devices or so that they are clearly
visible.
RISKS
Zone 1
Risk of crushing when
closing
Zone 2
Risk of cutting or crush-
ing between the gate leaf
and any adjoining fixed
sections
Zone 3
Risk of crushing with an
adjoining fixed section
upon opening
Copyright
©
2023 SOMFY ACTIVITES SA. All rights reserved.
Zone 3
Zone 2
Zone 1
Zone 5
Zone 4
SOLUTIONS
Obstacle detection built
into the drive.
The obstacle detection
must be confirmed as
being compliant with An-
nex A of standard EN
12453.
For operation with auto-
matic
closing,
install
photoelectric cells.
Obstacle detection built
into the drive.
The obstacle detection
must be confirmed as
being compliant with An-
nex A of standard EN
12453.
Illustration 1: Protection
by safety distances
p.11].
Obstacle detection built
into the drive.
The obstacle detection
must be confirmed as
being compliant with An-
nex A of standard EN
12453.
Illustration 2: Mechanical
protection
[}
p.11].
Eliminate any gap ≥ 8 mm
or ≤ 25 mm.
RISKS
Zone 4
Risk of crushing between
the secondary edges and
adjoining fixed sections
Zone 5
Risk of shearing between
the arms, or the arms
and motor cover
Risk of crushing between
the arms and gate
No protection is required if the gate has hold-down
control or if the danger zone is more than 2.5 m
above the ground, or at any other permanent access
level.
Illustration 1: Safety distances
Deformable cover ensuring a safety distance of 25
mm in the compressed position
[}
Illustration 2: Mechanical protection
SOLUTIONS
Obstacle detection built
into the drive.
The obstacle detection
must be confirmed as
being compliant with An-
nex A of standard EN
12453.
Eliminate any gap ≥ 8 mm
or ≤ 50 mm.
Obstacle detection built
into the drive.
The obstacle detection
must be confirmed as
being compliant with An-
nex A of standard EN
12453.
Illustration 1: Protection
by safety distances
p.11].
Section
EN
[}
11
Publicidad
