Descargar Imprimir esta página

Vornado FLIPPI V10 Guia Del Usuario página 7

Circulador de aire compacto

Publicidad

COMMANDES
L 'OSCILLATION
Le modèle V10 a
un commutateur
d'oscillation à l'arrière
de la base de l'unité.
Appuyez sur ( ) pour
activer le mouvement
d'oscillation. Appuyez
sur (O) pour y mettre fi n.
MARCHE/ARRÊT
Pour choisir la vitesse de
ventilateur élevée (III), moyenne
(II), basse (I), ou mettre
l'appareil hors tension (O).
38 Français
SERVICING WARNING—To reduce risk of fi re, electrical shock and injury
to persons, observe the following:
- Clean your product regularly, only as is instructed in this manual. Prior
to cleaning, turn off the power on your product and unplug. Do not use
gasoline, thinners, solvents, ammonias or other chemicals for cleaning.
Refer to the CLEANING instructions provided.
- Do not open appliance housing while product is plugged in. To avoid risk
of shock, all service and/or repairs must be done by a Vornado Authorized
Service Center.
- This product employs overload protection (fuse). A blown fuse indicates
an overload or short-circuit situation. If the fuse blows, unplug the product
from the outlet. Replace the fuse as per the user servicing instructions
(follow product marking for proper fuse rating) and check the product.
If the replacement fuse blows, a short-circuit may be present and the
product should be discarded or returned to an authorized service facility for
examination and/or repair.
User Servicing Instructions
1. Using the product controls, turn off the appliance.
2. Grasp the plug (not the cord) and disconnect from the outlet.
3. Risk of Fire. Replace fuse only with 2.5 Amp, 125 Volt fuse as approved
by Vornado Consumer Service. For an authorized replacement fuse,
please contact Vornado Consumer Service.
4. Once the replacement is received, use a small fl at-head screwdriver to
slide open the fuse cover (located on the plug) (See next page, Fig. A).
5. Remove fuse by using the screwdriver to gently lift each end of the
fuse (See next page, Fig. B).
6. Install the replacement fuse by using the screwdriver to gently push
each metal end of the fuse into the receptacle one at a time. Do not
English 7

Publicidad

loading