Johnson JR8V Serie Manual De Instrucciones página 79

Center of gravity position is shown in Figure 2.2:
Table 2.1
Model A B
252-335 940 825
400-450 940 825
500-560 1340 825
615-670 1340 825
730 1880 825
785-900 1880 825
252-450
A
REAR
B
FRONT
CENTER OF
GRAVITY
C
500-900
A
REAR
B
C CENTER OF
FRONT
NOTE
Use a leather belt that can adequately
support the weight of the unit, and has a
width ≤ 20 mm.
Images are for reference only. Please refer to
the actual product.
Do not remove any packaging while hoisting
the unit. Where the unit is not packed or the
package is damaged, use a gasket or
package to protect the unit.
The belt must have enough strength to bear
the weight of the unit; keep the machine
balanced and ensure the unit is lifted safely
and stably.
Forklift method
To move the unit with a forklift, insert the forks into
the opening at the bottom of the unit, as shown in
Figure 2.3.
For anti-corrosion models, put a pad on the forks to
prevent damage to the bottom frame paint of the
unit.
Unit: mm
C D
504 453
466 507
610 492
651 448
885 441
825 456
D
D
GRAVITY
Figure 2.2
13
2.2 Unboxing the Outdoor Unit
Take the unit out of the packing materials:
Be careful not to damage the unit when you use a
cutting tool to remove the wrapping film.
Remove the four nuts on the wooden back stand.
WARNING
Plastic film should be disposed of properly. Keep
away from children. Potential risk: Asphyxia.
2.3 Taking Out Accessories of
the Outdoor Unit
The accessories for the unit are stored in two parts.
Documents like the manual are located at the top of
the unit. Accessories like the pipes are located inside
the unit. The unit contains the following accessories:
Table 2.2 Accessories
Name Qty. Appearance
Owner's and
1
installation manual
Erp information
1
L-shaped pipe
2
connection
Build-out resistor 1
Wrench 1
1
Bluetooth Module
1
Magnetic ring
Figure 2.3
Function
To connect gas
and liquid pipes
To improve
communication
stability
To remove the
side plate
screws
Refer to attached
manual
Improve the
EMI effect of
communication
V.1