Publicidad
Idiomas disponibles
Idiomas disponibles
16"
Basics
1 Pick up the handset from the
base phone.
TALK/BATT
LOW lamp
2 Press
(TALK).
The TALK/BATT LOW lamp on
the handset and the IN USE
lamp on the base phone light up.
VOL
switch
Then you'll hear a dial tone. If
you hear error beeps, move
closer to the base phone.
3 Dial the phone number.
4 When you're done talking, press
or replace the handset on
the base phone.
The TALK/BATT LOW lamp on
CREDIAL/PAUSE )
the handset and the IN USE
Additional tasks
lamp on the base phone go off.
To
Do this
Put a call on hold
Press (HOLD).
The TALK/BATT LOW lamp flashes slowly.
Press
to resume the conversation.
Select a better channel
Press CCHANNEL ).
Adjust the handset
Set the VOL switch to H (high), M (middle) or L
volume
(low).
Switch to tone dialing
Press
while using the telephone after
temporarily
you're connected.
The line remains in tone dialing until disconnected.
Switch to another call
Press
to access the flash function.
("call waiting" service*)
Press
again to return to the first caller.
* You need to subscribe to the service from your telephone company.
Notes
¢ Before dialing, make sure you can hear the dial tone, otherwise you cannot
dial correctly.
¢ When the TALK/BATT LOW lamp repeats a set of two flashes, the base
phone is in use.
¢ When you set the handset volume to H (high), the volume will be raised
considerably. Under normal circumstances, set the volume to M (middle).
Basics
Publicidad
