Eaton TRIPP LITE Serie Manual Del Usuario página 18

2. Closure Installation
2
Position the two holes 14 in. (360 mm) apart (Figure 2-6).
3
Hammer the expansion bolt completely into the drilled holes. Rotate the bolt
clockwise to make the expansion sleeve wholly expanded, then rotate the nut
counterclockwise and remove the spring washer, flat washer and nut
(Figure 2-7).
18
04-063-93-47BE_RevA.indb 18 04-063-93-47BE_RevA.indb 18
Figure 2-6: Position of the holes
Figure 2-7: Install the expansion bolt
Unit: mm
1/31/2024 3:41:01 PM 1/31/2024 3:41:01 PM