Publicidad
Idiomas disponibles
Idiomas disponibles
Note:
After spot cleaning, the robot will automatically
return to the starting point and enter Standby mode.
Pause
When the robot is running, press any button
to pause it, press the
button to resume
cleaning, and press the
button to send it
back to the dock.
Note:
Placing a paused robot on the dock manually will
end the current cleanup.
Sleep
If the robot is paused for over 10 minutes,
it will go to sleep, and the power indicator
light will flash every few seconds. Press any
button to wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left in sleep
mode for more than 12 hours.
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period. When DND is on, the robot will not
automatically resume cleanup, the power
indicator light will dim, and the volume of
the voice prompts will lower.
Mop Washing
During cleaning, the robot automatically
determines when it should return to
the dock for mop washing and water
tank refilling to maximize its mopping
performance. During cleaning, tap Dock
button in the app to send robot back for
mop washing. When the robot is charging,
press and hold the
button on the robot or
tap Wash button in the app to manually start
washing. Press any button to stop washing.
Notes:
• To allow the robot to wash the mop automatically,
start the robot from the dock and do not move the
dock during cleaning.
• Watch out for hot water and do not touch the water outlet.
• You can set the wash frequency and washing mode in
the app.
Emptying
Auto-emptying will automatically begin
when the robot returns to the dock after
cleaning. To manually emptying, press
button on the docked robot or tap Empty
button in the app. Press any button to
stop emptying.
Notes:
• When auto-emptying has been left unused for a long
period, empty the dustbin manually and make sure
the air inlet is clear for optimal emptying performance.
• Auto emptying can be disabled through the app.
• Avoid frequent manual emptying.
Drying
Drying starts automatically after mop washing
or after cleaning are completed. To manually
start or stopping drying, tap the Drying button
in the app.
10
Notes:
• Drying duration can be modified in the app.
• Auto drying can be disabled through the app.
Charging
After cleaning, the robot will automatically
return to the dock to charge. In Pause mode,
press the
button to send the robot back to
the dock. The power indicator light will breath
as the robot charges.
Note:
If the robot fails to find the dock, it will
automatically return to its starting location. Place the
robot on the dock manually to recharge.
System Reset
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system. Press the Reset button,
and the robot will reset automatically.
Note:
After resetting the system, scheduled cleaning,
WiFi, etc. will be restored to factory settings.
Restoring Factory Settings
If the robot does not function properly after
a system reset, switch it on. Press and hold
the
button and at the same time, press the
Reset button until you hear the "Restoring
factory settings" voice prompt. The robot will
then be restored to factory settings.
Publicidad
