Publicidad
Idiomas disponibles
Idiomas disponibles
Robot Error
The power indicator of the robot will flash
red and a voice alert will sound. Follow the
voice prompts and instructions in the app
for troubleshooting.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually
will end the current cleanup.
Dock Error
The dock status indicator light will be
steady red. Follow the voice prompts and
instructions in the app for troubleshooting.
Routine Maintenance
D
Main Brush
D1
* Clean every 2 weeks and replace every 6-12 months
D1-1—Main Brush Cover
D1-2—Main Brush Cover Latches
D1-3—Main Brush
D1-4—Main Brush Caps
D1-5—Main Brush Bearing
D1-6—Turn over the robot and press the
main brush latches to remove the
main brush cover.
D1-7—Pull out the main brush and remove
the main brush bearing. Rotate the
main brush caps in the indicated
unlock direction to remove the caps,
and remove any entangled hair or
dirt at both ends of the main brush.
D1-8—Reinstall the main brush.
D1-9—Reinstall the main brush cover. Make
sure that the four teeth are fully
seated in the slot, and then press on
the main brush cover to lock it until
you hear a click.
Notes:
• Main brush should be wiped down with a wet cloth. If the
main brush is wet, air-dry it away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to
clean the main brush.
Side Brush
D2
* Clean monthly and replace every 3-6 months
Unscrew the side brush screw. Remove and
clean the side brush. Reinstall the brush and
tighten the screw.
Omni-Directional Wheel
D3
* Clean as required
D3-1—Use a tool, such as a small screwdriver,
to pry out the axle and take out the wheel.
Note:
The omni-directional wheel bracket cannot be removed.
D3-2—Rinse the wheel and the axle with
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it firmly in place.
Main Wheel
D4
* Clean as required
Clean the main wheel with a soft, dry cloth.
11
Dustbin
D5
* Clean as required
D5-1—Open the top cover of the robot and
press the dustbin latch to take out
the dustbin.
D5-2—Open the washable filter and empty
the dustbin.
D5-3—Fill the dustbin with clean water and
reinstall the washable filter. Gently
shake the dustbin, and then pour out
the dirty water.
Note:
To prevent blockage, only use clean water without
any cleaning liquid.
D5-4—Leave the dustbin and the washable
filter to dry.
Washable Filter
D6
* Clean every 2 weeks and replace the filter every 6-12 months
D6-1—Remove the filter.
D6-2—Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note:
Do not touch the surface of the filter with your
hands, brush, or hard objects to avoid potential damage.
D6-3—Allow at least 24 hours for the filter
to dry thoroughly and reinstall it.
Mop Cloths
D7
* Clean as required and replace every 1-3 months
D7-1—Remove the mop cloth from the mop
cloth mount. Clean the mop cloth and
air-dry it.
Publicidad
