Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting to the App
❶Download App
Search for "Roborock" in the App Store or
Google Play or scan the QR code to download
and install the app.
❷ Reset WiFi
1. Open the top cover and find the WiFi
indicator light.
2. Press and hold the
and
you hear the "Resetting WiFi" voice alert. The
reset is complete when the WiFi indicator
light flashes slowly. The robot will then wait
for a connection.
Note:
If you cannot connect to the robot due to your
router configuration, a forgotten password, or any other
reason, reset the WiFi and add your robot as a new device.
❸ Add Device
Open the Roborock App, tap the "Scan to
Connect" or "Search for Device" button and
add the device as instructed in the app.
Notes:
• The actual process may vary due to ongoing app updates.
Follow the instructions provided in the app.
• Only 2.4 GHz WiFi is supported.
• If the robot waits more than 30 minutes for a connection,
WiFi will be automatically disabled. If you want to
reconnect, reset the WiFi before proceeding.
Instructions for Use
C
On/Off
Press and hold the
robot. The power indicator light will turn on
and the robot will enter standby mode.
Press and hold the
robot and complete the cleaning cycle.
Note:
The robot cannot be turned off when it is being
charged.
buttons until
Filling the Water Tank
C1
Remove and open the clean water tank and
fill the tank with water to MAX. Close the lid,
lock the latch, and fit the tank back in place.
Notes:
• To prevent corrosion or damage, only use the Roborock
branded floor cleaner in the water tank.
• Do not add too much cleaning fluid to prevent the robot
from working improperly due to slipping.
• To avoid water tank deformation, do not place hot water
in the tank.
• If water marks remain on the water tank, wipe them
clean before reinstallation.
C2
Press the
robot will plan its cleaning route according
to its scan of the room. It splits a room
into zones, first draws out zone edges, and
then fills the zone in a zigzag pattern. In
so doing, the robot cleans all zones one by
one, efficiently cleaning the house.
C2-1—Zone 1 – Cleaned.
C2-2—Zone 2 – Cleaned.
C2-3—Zone 3 – In Progress.
button to turn on the
C2-4—Zone 4 – Next Zone.
Notes:
• To allow the robot to automatically vacuum and return
button to turn off the
• Cleaning cannot start if the battery level is too low.
• Before cleaning, tidy cables (including the power
• If cleaning is completed in less than 10 minutes, the
• If the battery runs low during the cleaning cycle,
• The robot will retract mop cloth mount when cleaning
• Before starting each cleaning task, make sure that the
Spot Cleaning
Press and hold the
cleaning in pause mode.
Cleaning range: The robot cleans a 1.5 m (4.9 ft) x
1.5 m (4.9 ft) square area centered on itself.
09
Starting Cleaning
button to start cleaning. The
to the dock, start the robot from the dock. Do not move
the dock during cleaning.
Allow the robot to charge before starting the cleanup.
cable of the dock) and valuables from the floor. Loose
items may be dragged by the robot, resulting in the
disconnection of electrical appliances or damage of
cables and property.
area will be cleaned twice.
the robot will automatically return to the dock. After
charging, the robot will resume where it left off.
the carpet. You can also set the carpet as a no-go
zone in the app to avoid it.
mop cloths have been properly installed.
button to start spot
Publicidad
