Zummo Z14 Manual De Usuario página 28

6. The machine features a motor overheating protection system, and therefore operation will
stop if it overheats. The display will show "Error" and the thermometer or tools icon
(depending on the model). In these cases you will have to wait for approximately ten
minutes for the motor to cool down and the display will then return to its normal status.
Check that the ventilation grills are clear.
7. If the machine does not display any message, this is due to a power failure. Check that the
switch is on and that the safety fuse has not blown.
6. MAINTENANCE MANUAL
•
The machine must be connected to earth to avoid any possible electric shocks to people or
damage to the equipment.
•
The plug should be easily accessible when installation has been completed. The use of extension
leads, adapters or multiple power points is not allowed.
•
Machines that are fitted without a Zummo cabinet must be placed on a flat surface at a minimum
height of 780 mm.
6.1. INSTALLATION
•
Warning! The machine weighs 58kg. We recommend two people carry the juicer. The best way to
carry it is to hold the bottom rear with one hand and then use the other hand to hold the machine
by the squeezing tray axles [Fig. 25].
•
Place the machine on a surface that is sufficiently rigid, stable and horizontal, and then secure it to
the surface by screwing the legs to the surface with M8 screws.
•
Machines that are not installed on a Zummo cabinet must be installed on a surface at a minimum
height of 800 mm. If it is installed on a lower surface, the lid accessory for the hopper should be
fitted.
•
The machine must be connected to earth to avoid any possible electric shocks to people or
damage to the equipment.
•
The plug must be accessible after installing the machine. The use of extension leads, adapters or
multiple power points is not allowed.
•
Make sure the voltage and frequency of the machine match those of the power supply. See
specifications plate [Fig. 26].
•
Plug the power cable into a socket with an effective earthing contact, duly protected by a 0.03A
differential circuit-breaker and only connect the juicer to this socket. Do not share it with other
appliances.
•
We recommend cleaning the squeezing system components before the first use (cups, squeezing
tray, balls, blade, ADAPT tray / SERVICE tank, complete automatic filter and front cover). We also
recommend cleaning the feeder area before the first use (inner hopper and hooper chute).
6.2. MAINTENANCE
28