Publicidad
Idiomas disponibles
Idiomas disponibles
GARANT Height gauge HG1
de
1.
General information
Read and observe the operating instructions, keep them as a reference for later and ensure they are accessible at
en
all times.
2.
Safety
bg
2.1.
GROUPED SAFETY MESSAGES
WARNING
da
Electric current
Risk of injury due to live components.
»
Before starting any installation or maintenance work, disconnect the device from the mains power supply.
fi
»
Use only the power supply unit supplied.
»
Do not open the power supply unit or the casing.
»
Only use indoors at low humidity.
fr
»
Do not store liquids in the vicinity of electrically live components.
»
Do not bend cables and plugs or subject them to tensile forces.
it
CAUTION
Leaking electrolyte
hr
Eyes and skin irritation can occur due to leaking, poisonous and corrosive electrolytes.
»
Avoid contact with your eyes and body.
»
In the event of contact, rinse out the affected area immediately with plenty of water and consult a doctor.
nl
2.2.
INTENDED USE
For both industrial and private use.
For use on grade 0 or 1 granite plates installed free of vibrations.
no
Use only in accordance with the technical data.
Use only when it is technically in good condition and safe to operate.
pl
Protected against solid foreign objects with a diameter ≥ 1.0 mm in accordance with IP 40.
2.3.
REASONABLY FORESEEABLE MISUSE
Avoid vibrations, jerky movements, shocks and impacts.
pt
Do not use in potentially explosive atmospheres.
Do not expose to strong heat, direct sunlight or open fire.
When replacing the rechargeable battery, only open the casing at the battery cover.
sv
Do not carry out any unauthorised modifications.
2.4.
PERSONAL PROTECTIVE EQUIPMENT
sk
Adhere to the national and regional regulations on safety and accident prevention. Select and provide protective work
wear, such as foot protection and protective gloves, that is appropriate for the respective activity and the expected risks.
3.
Device overview
es
3.1.
HEIGHT GAUGE HG1
A
hu
1
2
ro
3
lt
4
5
sl
6
cs
7
18
Millimess connection socket
Measurement slide
Positioning handle
Socket for standard holder for replaceable
measuring probe
Measuring device column
On/off switch
Control panel, rotatable and tilting
10
Thumbwheel for proportional control of the
speed of travel
11
Measurement start in negative direction
(down)
12
Air bearing push button
13
Grip (both sides)
i
Items 14–17 on the rear of the device
14
2 USB 3.1 ports (white)
15
Pin connector, 8-pin
Publicidad
