Garant HG1 Manual De Uso página 22

GARANT Height gauge HG1
de
5. Transport
i
en
Immediately on receipt check the product for damage in transport. If the product is damaged, do not install or commission
it.
CAUTION
bg
Transporting to the place of installation
The net weight is high – risk of injury if it is lifted improperly.
» Wear foot protection and safety gloves.
da
» Make sure the paths for movement and transport are clear.
» Ensure during movement and transport that all drawers and cupboard doors are closed and locked.
fi
» At least two persons must be employed to transport it to the installation location.
NOTICE
fr
Improper transport
Damage to transport items.
» Do not drag them across the floor.
it
» When items of packaging are being transported they must be upright, secured with ropes and protected against slip-
ping.
» When putting them down, do so slowly and evenly.
hr
» Do not remove the transport packaging until immediately before installation.
6. Initial commissioning
nl
i
The steps described in this section are documented in detail in the online help. For numbers, see Buttons and symbols over-
view [} Page 19].
no
6.1. ASSEMBLING HEIGHT GAUGE HG1
C D
,
pl 1. Take the control panel (2) and data cable (3) out of the transport box.
2. Take the column for height gauge HG1 (1) out of the transport box and unpack it.
3. Insert the standard holder for measuring probes so that it is turned 180° upwards.
pt
4. Unscrew the fixing screw for the measurement slide (10 a).
5. Move the measurement slide upwards on the positioning handle (10 b) and secure its height.
6. Turn the standard holder for measuring probes downwards 180° (10 c).
sv
7. Unscrew the fastening screws on the safety bar and remove the safety bar (11).
8. Insert the blind caps (9) (11 d).
9. Unpack the power supply unit (7).
sk
10. Connect the rechargeable battery. See Replacing the rechargeable battery [} Page 25].
11. Use the cheese-head screws (6) to secure the control panel (2) to the carrier (12).
12. Connect the control panel (2) to height gauge HG1 using the connecting cable (3).
es
» Height gauge HG1 is now assembled.
6.2. CONNECTING THE POWER SUPPLY
hu
DANGER
Electric current
Risk of fatal electric shock.
ro
» Before starting any installation, cleaning or maintenance work, disconnect the device from the mains power supply.
» Electrical installation, maintenance and repair may be performed only by trained specialists.
» For indoor use only.
lt
» If power cables or sockets are damaged, immediately disconnect the device from the power supply, do not continue to
use the device.
» Do not drive over, pinch or crush cables.
sl
» Do not store liquids in the vicinity of electrically live components.
» Do not operate with wet or damp hands.
» Check the power supply against the rated voltage and frequency shown on the nameplate, and ensure they are
cs
identical.
22