Publicidad
Idiomas disponibles
Idiomas disponibles
ü Height gauge HG1 has been unpacked and set up.
1. Connect the country-specific mains connecting cable to the power supply unit.
2. Connect the pin connector of the power supply unit to height gauge HG1.
3. Connect the power supply unit to the mains power.
»
The power supply is now established.
6.3.
CHARGING THE RECHARGEABLE BATTERY
Charge the battery:
During initial commissioning.
If it was last used more than six months ago.
If the battery symbol appears on the display.
The battery also charges when height gauge HG1 is switched off.
ü Power supply unit connected to power supply.
ü Control panel connected to height gauge HG1.
1. The battery must be charged for at least 5 minutes before height gauge HG1 can be used.
6.4.
SWITCHING ON WITH A REFERENCE POINT RUN
A
1. Press the on/off switch (6) on the control panel.
»
Height gauge HG1 is switched on.
»
The probe performs a reference point run in positive and negative directions.
»
The zero point of the z-axis is positioned on the measuring plate.
6.5.
MAKING BASIC SETTINGS
1. Tap "Settings (2.01)" on the menu bar.
2. In the "Settings" menu, tap "Other entries (2.02)".
»
The "Device settings" menu appears.
3. Set the language, time and date.
4. Select the timeframe for auto power off.
5. Select the timeframe for auto power off for the backlight.
6. Select the backlight brightness.
7. If required, activate password protection.
8. Once all settings have been defined, tap "Confirm action (2.12)" until the "Settings" menu closes.
»
The basic settings are now set.
6.6.
MEASURE CONTACT POINT
1. Insert the measuring probe in the carrier.
2. Position the adjustment block on the measuring plate.
3. Tap "Measure contact point (2.05)" on the menu bar.
4. On the function button bar, tap the required measurement procedure (3.01–3.04).
5. Use the positioning handle to set the contact point to the height of the adjustment block.
6. Align the adjustment block with the contact point.
»
The measurement procedure is performed and visualised in the user interface.
»
The determined contact point constant is displayed in the upper display area.
7.
Operation
i
The steps described in this section are documented in detail in the online help. For numbers, see Buttons and symbols over-
view [} Page 19].
7.1.
ADJUSTING THE HEIGHT OF THE CONTACT POINT
A
1. Use the positioning handle (3) to adjust the height of the measurement slide by hand.
or
2. Use the thumbwheel (10) to adjust the motorised measurement slide. The measurement slide's speed of travel is pro-
portional to the movement of the thumbwheel.
www.hoffmann-group.com
de
en
bg
da
fi
fr
it
hr
nl
no
pl
pt
sv
sk
es
hu
ro
lt
sl
cs
23
Publicidad
