Triango 60 F
CAUTION
The lamp head must be installed before the spring
force is adjusted.
Move the spring arm into the highest position.
Remove the side plastic covers and push the round
plastic flap up along the spring arm
Adjust the screw with a 4mm Allen key
Turn the screw clockwise (+) to increase the spring force
(as the spring arm lowers)
Turn the screw anticlockwise (-) to decrease the spring
force (as the spring arm rises)
10. DEINSTALLATION
DANGER
Danger to life through an electric shock.
Before disassembly, the light must be completely
disconnected from the mains voltage.
WARNING
Risk of injury
The spring arm is under a high spring force. If the end
device is not removed in the uppermost spring arm
position, the spring arm will spring up and can cause
serious injuries. Only disassemble the end device when
the spring arm is in the uppermost position
10.1 Disposal
Do not put the light in the household waste. Dispose
of the light at a disposal point in accordance with
local regulations or give it to a dealer with the
appropriate service.
Cut the cable directly at the housing.
The products listed above are over 95% recyclable.
The lights are designed to be recyclable so that
a high proportion of the materials used can be
recycled or used to generate energy after the end
of the service life of these products. They do not
contain any dangerous substances or substances
that require monitoring.
11. ACCESSORIES
Handle (item number D10.442.000)
Grip cover (item number D15.445.000)
12. ADDITIONAL INFORMATION
The light itself is maintenance-free.
Additional documentation for this product can be requested
from the manufacturer on request.
The use of this light does not create any risks that could affect
other devices.
To save energy, the light should only be switched on when
it is actually being used.
All serious incidents related to the device must be reported
to the manufacturer or its representative and to the
competent authority of the Member State where the user
is established.
ENG
39