Publicidad
Idiomas disponibles
Idiomas disponibles
GB
IE
Assembling the carrying
strap
A carrying strap (9) can be hooked onto
the sides of the container for fatigue-free
work.
1. To do this, slide the openings of the
carrying strap (9) over the strap faste-
ning (5) on both sides of the container
(10).
2. Adjust the desired strap length using
the length adjuster (24).
For optimal wearing comfort, we re-
commend keeping the strap holder (5)
at hip level if you wear the carrying
strap (9) over your shoulder.
The device can now be carried over the
shoulder with the carrying strap (9) in ad-
dition to the handle (12).
Filling with water
The device may only be operated
with pure water!
Caution!
Do not fill with acidic, corrosive or
flammable liquids.
Caution! Do not fill with impregna-
ting agents or disinfectants, varni-
shes, glazes, greases, mineral oils
or synthetically produced oils.
The spray container (10) can be filled with
a maximum of 5 litres of water.
30
1. Place the pressure sprayer on a level
surface.
2
Turn the screw cap (11) anticlockwise.
Fill with water. Pay attention to the sca-
le (16) on the container (10) so as not
to exceed the maximum filling quantity.
3. After filling, screw the screw cap (11)
clockwise with both hands.
4. Make sure that the screw cap fits tightly.
Operation
Caution! Wear suitable personal
protective equipment!
Removing/inserting the
battery
The device can be operated either with
X 20 V TEAM or X 12 V TEAM batteries.
1. Fold up the battery cover (15).
2. There are 2 different battery
compartments.
The upper battery compartment (
intended for use with the 12 V battery.
The lower battery compartment (
intended for the 20 V battery.
3. Push the desired battery (21) fully into
the corresponding compartment. You will
hear it click into place.
4. To remove the battery (21) from the
device, press the release buttons (20) on
the battery and pull the battery out.
25) is
26) is
Publicidad
