GE 21 Manual Del Propietario Y Instalación página 10

About the freezer.
Not all features are on all models.
Appearance andfeatures mayvary
Freezer Shelves and Baskets
0 A shelf above the ice storage bin
0 A full-width upper basket in top drawer
An ice storage bin
A shallow full-width upper basket in
bottom drawer
A deep full-width lower basket in
bottom drawer
Appearance may vary
Basket Removal (Top Drawer)
To remove the full-width basket on top
freezer drawer models:
Open the top freezer drawer until it stops.
The freezer basket rests on the inside
tabs on the drawer slides.
Lift the front end of the basket so that the
front two alignment tabs come out of the
slide bracket first. Then rotate the front
edge of the basket up while lifting the
remaining two rear alignment tabs out
of the slide bracket.
Hake sure the plastic sleeves remain
attached to the 4 slots on the slide
brackets.
When replacing the full-width basket:
Tilt the basket back and lower it down into
the drawer. Rotate the basket to a horizontal
position and press it down into the
4 alignment tabs.
NOTE:Alwags be sure that all/4 basket slots
are engaged in the slide brackets before
sliding back into the freezer.
Appearance mayvary
Appearance mayvary
Basket Removal (Bottom Drawer)
To remove the full-width upper basket:
Open the bottom freezer drawer until
it stops.
Pull the basket out to the stop location.
Lift the basket up at the front to releaseit
from the slides.
Lift the back up and out of the slide.
To remove the deep full-width lower basket:
Open the bottom freezer drawer until
it stops.
Lift the rear of the basket up so the two
rear alignment tabs are pulled out of the
slide bracket.
Rotate the basket up and out of the
drawer.
When replacing the full-width upper basket:
Drop the upper rear wire rail of the basket
into place behind the plastic tabs. Then drop
the front end of the basket into place and
slide the basket back into the closed position.
NOTE:Alwags be sure to fullg close this
basket.
When replacing the deep full-width lower
basket:
Lower the front end of the basket into
position so that the two front alignment tabs
enter the slide bracket. Then lower the rear of
the basket into place, ensuring the two rear
alignment tabs are pressed into place in the
slide bracket.
NOTE:Alwags be sure that all/4 basket slots
are engaged in the slide brackets before
sliding back into the freezer.
10