GE 21 Manual Del Propietario Y Instalación página 20

Installation Instructions
INSTALLING THE REFRIGERATOR
{cont.}
I_ REMOVE THE FRESH FOOD
DOOR HANDLE
(For placement in the installation location or
reversal of the handles - on some models}
Stainless steel (on some models}:
@ REMOVING THE
DOORHANDLE:
Loosenthe set
screws with the
3/32" Allen wrench
and remove the
handle. NOTE:For
Double Door models,
follow the same
procedure on the
opposite door.
1
Badge
J
Mounting
Fasteners __
(appearance m avva_)
Plastic handle (on some models):
O REMOVING THE DOORHANDLE: D epressthe tab on
the underside of the handle and slide the handle up
and off of the mounting fasteners.
0 REVERSING THE
DOORHANDLE
(on some models):
• Removethe
handle mounting
fasteners with a
1/4" Allen wrench
and transfer the
handle mounting
fasteners to the
right side.
• Removethe logo
badge.
• Removeand
transfer the plug
button to the left
Mounting
Fasteners
f
Badge
(appearance may vary)
side of the fresh food door. NOTE:Use a flat plastic
edge to prevent damaging the door. Removeang
adhesive on the door with a mild detergent. Remove
the paper covering on the adhesive backing on the
logo badge prior to carefullg attaching the badge to
the door.
[Z] REMOVE THE TOP AND BOTTOM
FREEZER DRAWER HANDLES
Stainless steel and plastic handles:
@ Loosenthe set screws located on the underside of
the handle with the 1/8" Allen wrench and remove
the handle.
NOTE:If the handle mounting fasteners need to be
tightened or removed, use a 1/4" Allen wrench.
@
0
2O