GE 21 Manual Del Propietario Y Instalación página 19

Installation Instructions
CONNECTING THE REFRIGERATOR
TO THE HOUSE WATER LINE {cont.}
If you are using copper tubing, place a
compression nut and ferrule (sleeve) onto the
end of the tubing coming from the house cold
water supplg.
If gou are using the GE SmartConnect'"
tubing, the nuts are already assembled to the
tubing.
r_ if you are using copper tubing, insert the end
of the tubing into the refrigerator connection,
at the back of the refrigerator, as far as
possible. While holding the tubing, tighten
the fitting.
If you are using GE SmartConnect'" tubing,
insert the molded end of the tubing into the
refrigerator connection, at the back of the
refrigerator, and tighten the compression
nut until it is hand tight. Then tighten one
additional turn with a wrench. Overtightening
may cause leaks.
r_ Fasten the tubing into the clamp provided to
hold it in position. You may need to pry open
the clamp.
One of the illustrations below will look like the
connection on your refrigerator.
Icemaker-Ready models
Tubing
Clamp
1/4" Copper
Tubing
1/4"
Compression
Nut
Ferrule
(sleeve)
Refrigerator
Connection
SmartConnecf M
Tubing
Icemaker-lnstalled Models
Ferrule 1/4"
Refrigerator (sleeve) Compression
Connection
SmartConnecP
Tubing
1/4" Tubing
Tubing Clamp
[_l TURN ON THE WATER SUPPLY
(icemaker and dispenser models)
Turn the water on at the shutoff valve (house
water supply) and check for any leaks.
[] PLUG IN THE REFRIGERATOR
On models with an icemaker, before plugging in
the refrigerator, make sure the icemaker power
switch is set to the 0 (off) position.
See the grounding information attached to the
power cord.
r41 PUT THE REFRIGERATOR IN PLACE
Move the refrigerator to its final location. Make
sure the back side of the refrigerator engages the
anti-tip bracket properlg. The anti-tip floor bracket
should line up with the cutout in the back bottom
of the refrigerator, and fit through the cutout when
the refrigerator is pushed into position. (Refer to
page 16, Step 2A for more information.)
19
I'_ LEVEL THE REFRIGERATOR
Turn the front roller adjusting
screws clockwise to raise the
refrigerator, counterclockwise
to lower it. Usea 3/8" hex
wrench with extension, or an
adjustable wrench.
Rolleradjustingscrews
To adjust the rollers on 21' Counter Depth models:
These models also have rear adjustable rollers so Uou
can align the refrigerator with uour kitchen cabinets.
Usea 3/8" hex wrench with extension to turn the
screws for the rear rollers-clockwise to raise the
refrigerator, counterclockwise to lower it.