GE 21 Manual Del Propietario Y Instalación página 15

Installatio
I str cti
Refri erator
Models 21 and 25
Double Freezer Drawers
T w
Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT-
Savethese instructions
for local
inspector's use.
• IMPORTANT - Observe a,
governing
codes and
ordinances.
• Note to Installer - Be sure to leavethese instructions with
the Consumer.
• Note to Consumer- Keepthese instructions for future
reference.
• Skill level- Installation of this appliance requires basic
mechanical skills.
• Completion time- Refrigerator Installation
20 minutes
Water Line Installation
30 minutes
Anti-Tip Bracket Installation
20 minutes
• Proper installation is the responsibilitgof the installer.
• Product failure due to improper installation is not covered
under the Warrants.
PREPARATION
MOVING THE REFRIGERATOR INDOORS
If the refrigerator will not fit through a doorwag, the
refrigerator door and freezer drawer can be removed.
• To remove the refrigerator door,see Step i in the
Reversingthe Door Swing section.
• To remove the freezer drawer, see the Removingthe
FreezerDrawer section.
WATER SUPPLY TO THE ICEMAKER AND DISPENSER
ION SOME MODELS)
If the refrigerator has an icemaker, it will have to be
connected to a cold water line.A GEwater supplUkit
(containing tubing, shutoff valve,fittings and instructions)
is available at extra cost from sour dealer,bUvisiting our
Website at GEAppliances.com (in Canada at
www.GEAppliances.ca) or from Parts and Accessories,
800.626.2002(In Canada 1.888.261.3055).
MATERIALS YOU MAY NEED
(notincluded)
LagBolts
Drill Bit Appropriatefor Anchors
AnchorSleeves
ForAnti-Tip BracketMounted on CONCRETE F loorsOnly
TOOLS YOU MAY NEED
AdjustableWrench
3/8" and5/16" Socket
Ratchet/Driver
1/4" OuterDiameter
Compression N ut
andFerrule (sleeve)(icemaker
modelsonly)
Phillips-Head Screwdriver
3/32", 1/8" and1/4"
Allen wrenches
1/8" Drill Bit and
Electricor HandDrill
Tapemeasure
Pencil
1/4" Nut Driver
Wire Cutters
Level
15