Installation
Instructions
INSTALLING THE ANTI-TIP FLOOR BRACKET Ion21ft.
models}
-ZIWARNING
Under certain
circumstances,
this refrigerator
can tip forward.
Injury to persons can result.
Install Anti-Tip
Bracket
packed with this
refrigerator.
[]
MEASURE CABINET OPENING
AVAILABLE VS. REFRIGERATOR WIDTH
Measure width of cabinet opening where
refrigerator
will be placed, W.
Be sure to account for anLI countertop
overhang,
baseboard
thickness and anLI
clearance
desired. Width, W, should not be less
than 36 inches. The refrigerator
will be placed
approximatelLI
in the middle of this opening.
Baseboard
RearWall
Thickness
or Countertop
_i
i_
Overhang
,
(Whichever
W
_"'
Is Greater)Plus
Any Desired
Clearance
REFRIGERATOR
RHSide
Front
[]
%
LOCATING THE ANTI-TIP
FLOOR BRACKET
Place the anti-tip floor bracket Iocator template
(included inside the anti-tip
kit) onto the floor
up against the rear wall, within W, and in line
with the desired location of the RH side of the
refrigerator
(see Figure 1).
Figure1 - Installation Overview
2 Wall Holes
Refrigerator
Sheet
rB] Place the anti-tip floor bracket onto the Iocator
template
with its RH floor holes lined up with
the floor holes indicated on the template
sheet,
approximatelg
7Ya" from the edge of the sheet
or the RH side of the refrigerator.
E]
Hold down in position and use the anti-tip floor
bracket as a template
for marking the holes
based upon Llour configuration
and tLIpe of
construction
as shown in Step 3. Mark the hole
locations with a pencil, nail or awl.
NOTE:
• It is REQUIRED to use at least 2 screws to
mount the floor bracket (one on each side of
the anti-tip floor bracket). Both must be into
either the wall or the floor. Figure 2 indicates
all the acceptable
mounting
configurations
for screws. Identifg the screw holes on the
anti-tip floor bracket for gour configuration.
16