GE 21 Manual Del Propietario Y Instalación página 24

Installation Instructions
REMOVING THE FREEZER DRAWERS
(cont.}
The freezer drawers can be removed, if needed, to
fit through tight areas.
Read these instructions completely and carefully.
BOTTOM DRAWER
I_ REMOVE THE UPPER BASKET
[_ Open the bottom freezer drawer until it stops.
r_ Pull the basket out to the stop location.
r_ Lift the basket up at the front to release it from
the slides.
r_ Lift the back up and out of the slide.
REMOVE THE LOWER BASKET
[] Open the bottom freezer drawer until it stops.
[] Lift the rear of the basket up so the two rear
alignment tabs are pulled out of the slide bracket.
Rotate the basket up and out of the drawer.
IYI REMOVE THE DRAWER FRONT FROM
THE SLIDES
r_ Remove the ]0 hex head screws from the door
and remove the door.
\
r_ set the drawer front on a non-scratching
surface.
r_ Push the rail assemblies back into the cabinet.
[] REMOVE THE BASE GRILLE
(if needed)
If, after removing the freezer drawers and
refrigerator door, the refrigerator will still not fit
through a doorwag, the base grille can be
removed.
r_ Remove the base grille bg removing the
2 Phillips-head screws.
24