Publicidad
OPERATING YOUR POLE SAW
ADJUSTING TELESCOPING POLE (See Figure 6)
‡ Remove the battery pack from the pole saw.
‡ Rotate the collar counterclockwise to loosen.
‡ Push poles towards each other to shorten the pole or pull away from each other to lengthen
the pole.
127( ([WHQG WKH SROH RQO\ WR WKH OHQJWK UHTXLUHG WR UHDFK WKH OLPE EHLQJ FXW 'R QRW H[WHQG WKH KDQGOH
above waist height.
‡ When the desired length is achieved, rotate the collar clockwise to secure.
NOTE: Adjust hand placement on the shaft of the pole saw to keep proper balance. Do not attempt to use the
pole saw at a length which does not allow you to achieve proper footing and balance at all times.
ASSEMBLING THE POLES (See Figure 6)
‡ Remove the battery pack from the pole saw.
‡ ,QVHUW KDQGOH SROH LQWR LQWHUPHGLDWH SROH RU SRZHUKHDG SROH ¿UPO\
‡ Turn the collar clockwise to lock the poles together.
127( $VVHPEOH SROHV RQO\ WR WKH OHQJWK UHTXLUHG WR UHDFK WKH OLPE EHLQJ FXW 'R QRW H[WHQG WKH KDQGOH
above waist height.
NOTE: Adjust hand placement on the shaft of the pole saw to keep proper balance. Do not attempt to use the
pole saw at a length which does not allow you to achieve proper footing and balance at all times.
Collar
Fig. 6
16
Publicidad
