Publicidad
OPERATING YOUR POLE SAW
LIMBING AND PRUNING (See Figure 9-10)
This unit is designed for trimming small branches and limbs up to 6" (15.2 cm) in diameter. For
best results, observe the following precautions.
‡ Plan the cut carefully. Be aware of the direction in which the branch will fall.
‡ Branches may fall in unexpected directions. Do not stand directly under the branch being cut.
‡ The most typical cutting application is to position the unit at an angle of 60° or less, depending
‡ Remove long branches in several stages.
‡
‡ Work slowly, keeping both hands on the saw with a firm grip. Maintain secure footing and
balance.
‡ Keep the tree between you and the chain while limbing. Cut from side of tree opposite branch
you are cutting.
‡ Do not cut from a ladder; this is extremely dangerous. Leave this operation for professionals.
‡
out to reduce the weight.
Following proper cutting procedures will prevent stripping the bark from the main member.
‡ Do not use the pole saw for felling or bucking.
‡ To prevent electrocution, do not operate within 50' (15 m) of overhead electrical lines.
‡ Keep bystanders at least 50' (15 m) away.
60° MAXIMUM
Fig. 9
18
(15 m)
Fig. 10
Publicidad
