Publicidad
MAINTENANCE
CHAIN OILER (See Figure 20)
W A R N I N G
To avoid possible serious injury, stop the motor and remove the battery from the pole saw
before replacing the bar, chain, or performing any maintenance operation.
‡ Use Premium Bar and Chain Lubricant. It is designed for chains and chain oilers and is
formulated to perform over a wide temperature range with no dilution required.
‡ Remove the cap and carefully pour approximately 2 oz (57 g) of bar and chain lubricant into
the bar lube reservoir.
‡ Replace the cap and tighten securely.
‡
NOTE: Do not use dirty, used, or otherwise contaminated lubricants. Damage may occur to the oil pump, bar,
or chain.
the foam.
Remove
Cap
Bar Lube Reservoir
22
Fig. 20
Publicidad
