Audi 8S8.071.126 Instrucciones De Montaje página 32

Installation instructions - TT Coupé 2015▶
Edition 07/2014
The gap -a- must not exceed 1 mm.
If the rubber supports on the support bracket housing are not
flush to the surface, we recommend that you have the width ad-
justment checked by a qualified workshop
bar width" on page 14. Remove the roof bars before doing so.
– Gently tighten the bolts -13- alternately using the torque
wrench -15-.
– Check the position of the support base housing -A- and claw
fastener -B- and correct if necessary.
– Tighten one tensioning bolt -13- after another using the tor-
que wrench -15- until the torque wrench makes an audible
clicking sound. This indicates that the correct torque has
been applied.
– Close the cover flap -16- and lock the lock -17- with the key
-18-.
Installing the rear roof bar
– Install the rear roof bar in the same way as the front roof bar.
Note
The illustration shows the positioning bolts for the rear roof bar.
4.2 Installing add-on components
– Secure the add-on components in accordance with the rele-
vant installation instructions.
12
4 Installing/removing roof bars on vehicle
⇒ " Setting the roof