Audi 8S8.071.126 Instrucciones De Montaje página 35

– Adjust the roof bar so that the rubber support on the right-
hand support bracket housing sits flush with the roof edge
-arrow-.
The gap -a- must not exceed 1 mm.
– Tighten the hexagon bolt -2- to 8 Nm.
– Repeat the procedure on the other roof bar if necessary.
WARNING
Check that all hexagon bolts have been tightened (8 Nm).
If this guideline is not observed, this can result in the roof
bars becoming loose or falling off — risk of accident!
Installation instructions - TT Coupé 2015▶
4 Installing/removing roof bars on vehicle
Edition 07/2014
15