Publicidad
Idiomas disponibles
Idiomas disponibles
– To install the add-on components, remove the profile cap -1-
from the profile tube -5- -arrow A-.
– Insert the add-on components in the T groove -arrow B-.
– Slide the profile cap -1- back on -arrow C-.
When the add-on components are not in use, secure the T
groove with the profile cover -4-.
– Adjust the profile cover -4- to the length of the roof bars with
the profile caps -1- closed.
– Place the profile cover -4- on the T groove on the profile
tube -5- and press the cover into the T groove -arrow-.
Note
◆ When driving with a roof load, ensure that the German Road
Traffic Regulations (StVZO) or any country-specific regula-
tions are observed.
◆ For reasons of convenience, it is common for the roof bars
with/without add-on components to remain on the vehicle,
even if they are not in use. As a result of the increased wind
resistance, your vehicle will consume more fuel and will pro-
duce additional noise.
◆ We therefore recommend that you remove the roof bars af-
ter use.
◆ Increased wind noise can result from driving with the roof
bars attached.
4.3
Removing the roof bars from the vehi-
cle
– Remove the load and the add-on components.
– Open the lock using the key and open the cover flap -16-.
Note
The illustration shows the front roof bar.
– Unscrew the left and right tensioning bolts -13- alternately
using the torque wrench -15- until obvious resistance is felt.
– Slide the claw fastener -12- against the direction of travel un-
til the stop.
– Detach the left and right-hand claw fasteners -12- from the
positioning bolts -X- and hook the "lugs" into the installation
position on the support bracket -9-.
– Remove the roof bars from the vehicle roof.
Installation instructions - TT Coupé 2015▶
4 Installing/removing roof bars on vehicle
Edition 07/2014
13
Publicidad
