Publicidad
Idiomas disponibles
Idiomas disponibles
E,- display and numbers
F display and numbers
If an E r and a series of numbers appear in the display panel, there is a fault in the
electronic system. Turn the appliance off and back on at the fuse or circuit breaker.
Call customer service if the same display appears again.
If an F and a number flash in alternation on the displays, your appliance has
detected a fault. Refer to the following table for possible remedies.
Visual indication
Fault
Measure
F2,
An internal error was
Disconnect the appliance from the power
produced while the
source. Wait a few seconds before connecting it
cooktop was working,
again.
If the symbol appears again, call customer
service.
F2
The element is too hot
and has turned off.
The pot or pan is too
close to the control
panel.
F8
The element has been
in constant operation
for too long.
c _
The power voltage is
too low.
c2/c9
The element has
overheated.
U4'00
The cooktop is
connected incorrectly.
Remove the pans from the elements. F2
disappears when you acknowledge the display
(by pressing a touch key) and the element has
cooled sufficiently. Wait a few minutes until the
elements have cooled down slightly. If ,c2
appears again after the element is turned back
on, the cooktop is still too hot. Turn off the
elements and allow them to cool further.
Verify that the pot or pan is properly positioned
on the element. Verify that nothing hot is on the
touch key panel. Remove the hot item from the
control area. Wait a few minutes for the touch
key panel to cool. If ,c4'appears again after the
element is turned back on, call customer service.
The automatic shut off was activated.
Turn the element off.
You can turn it back on again immediately.
Turn off the cooktop. Wait a few seconds before
turning it back on.
If the indication continues, contact your
electricity supplier.
It has been automatically deactivated to protect
your cooktop.
Wait a few minutes for it to cool down and switch
it back on again.
Disconnect the appliance from the power source
at the circuit breaker or fuse. Check the
connection and connect it again correctly.
If U4'P_,£ appears again, call customer service.
Notes
The heat is switched on and off to regulate the temperature of the element; this
means that the red glow below the element is not always visible. When you select a
low heat setting, the element turns off more frequently, while at a higher setting it
only turns off occasionally. Even at the highest level, the element turns off and on.
As the element is heating up, there may be a light buzzing.
The brightness of the glow may vary from element to element. Depending on your
line of vision, the red glow may appear to extend beyond the marked edge of the
element.
These are technical characteristics and have no impact on quality or function.
2O
Publicidad
