Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Note:
The
application
specifications of the product may be
changed without prior notice to improve
the quality of the product. The application
and technical specifications of the product
may differ from the related energy
efficiency tests or the test reports related,
etc.
ASSEMBLY AND INSTALLATION
The installation of electrical
connections must be carried
out exclusively by authorized
and qualified professionals.
Turn off the electricity before
the
washing
installed. If electricity is not
disconnected it may lead to
electrical shock or death.
For safety reasons: do not use
extension cables, or power
strips
Under no circumstances cut or
remove the earth wire.
Before
using
this
the packaging and visually inspect the
product. If you think the appliance could be
damaged, please contact the selling point
where you purchased it.
• The
manufacturer
responsible for any damages caused by
an incorrect installation.
• Two or more people are needed to install
or move this appliance. Otherwise there
is the risk of physical injuries.
• Before using the product for the first
time remove the protective layer on all
the parts.
• Make sure the voltage of the room in
which the appliance is going to be
installed matches the voltage indicated
in the plate of the appliance where you
can find the main features, and also
that the socket is correctly earth wired.
• Use exclusively the parts supplied or
original replacement hoses.
76
and
technical
machine
with
this
appliance.
appliance,
remove
will
not
• The assembly and installation must
be carried out by a qualified technician
who will be responsible for the correct
operation of the appliance in the
designated place where it has been
installed.
• Keep the area where the washing
machine
damages caused by cockroaches or any
other plague will not be covered by the
warranty.
Removing the transport bolts:
Transport bolts: The washing
machines have bolts fixed to
prevent
during the transport.
is
To
prevent
transportation, 4 screws are installed in
the machine.
Before using the washer, the screws must
be removed (Figure 04 on page 5). Strong
vibrations, noise and problems will occur
if the screws are not removed:
• Use the enclosed wrench (picture 03 on
page 5, Fig. DD) to loosen the 4 screws
(Fig. 1).
• Turn the screws slightly and then pull
the head of each screw through the
wide part of the hole. Keep the screws
and wrench (Fig. 2).
• Note
that
be
reassembled when the washer is
moved.
• Use the plugs provided (Picture 03 on
page 5, Fig. CC) to seal the socket holes
(Fig. 3).
Installation
Installation Requirements:
Before installing the washer, you must
select a location that meets the following
requirements:
• Surface area:
• The washer must be installed on a
rigid, dry and level surface.
• The tilt angle must be less than 1
degree (if the surface is uneven, adjust
the height of the feet according to the
is
installed
clean.
internal
internal
damage
the
screws
Any
damages
during
must
be
Publicidad
