Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
are set to the factory position, check the
diagonals of the product for vibration.
To do this, use both hands to grasp
opposite corners of the top of the panel
and shake it vertically downward.
Check both diagonals and if the washer
is unstable (shaking), the adjustable
feet need to be adjusted (Fig. 2).
• To correct the position in case of
vibration, loosen the locking nut in
the direction indicated in the pictures
(Fig.3 and 4) until the correct height
is reached, i.e. until the support foot is
fully seated and the machine does not
shake.
• Finally, use the wrench to turn the lock
nut until it is tight with the washer body
to lock it (Fig.5.) (you can also slightly
fix the foot with your hand to prevent
it from moving again). Make sure that
everything is securely fixed and that the
washer does not produce any abnormal
vibration or wobble that could damage
the washer during operation.
Water supply pipe connection
Do
not
Doing so may damage the
valves, causing leakage and
material damage.
• Connecting to a threaded water inlet
(See picture 06 on page 6)
• Connect the hose to the faucet. Then
turn the connector clockwise as
shown (Fig. 1).
• Connect the other end of the hose
to the inlet valve on the back of the
washer. Turn the hose clockwise to
tighten. (Fig. 2).
• Open the faucet and check for water
leaks around the connections. If there
are any leaks, repeat the above steps.
(Fig. 3)
• Connecting to an unthreaded water
inlet (See picture 07 on page 6)
• Remove the adapter (EE) from the
hose (FF).(Fig.1)
• Use a screwdriver to loosen the four
screws of the adapter (Fig.2).
78
over-tighten
hoses.
• While holding the adapter, turn the
part (GG) in the direction of the arrow
to loosen it by 5 mm (Fig.3).
• Insert
the
tap
and
while
lifting
Then turn the part (GG) in the direction
of the arrow to tighten it (Fig.4).
• Connect the hose to the adapter while
pulling the part (HH) down. Then
release the part (HH), the hose will
snap into the adapter with a click.
(Fig. 5)
• Finally, connect the other end of the
hose to the inlet valve on the back of
the washer. Turn the hose clockwise
to tighten it (see Figure 06 on page 6.
Figure 2).
• Open the faucet and check for water
leaks around the connections. If there
are leaks, repeat the above steps (see
Figure 06 on page 6. Figure 3).
Note: If the hose leaks after connection,
repeat the steps to connect the inlet hose.
Note:
Do
not
Note: Carefully check the inlet hose
connection each time before using the
washer.
Connecting the drain hose
See picture 08 on page 7.
• The drain hose should be placed at a
height of 65-100 cm above the floor,
otherwise it may cause poor drainage.
• You can use the supplied drain hose
bracket to connect the drain hose to
the wall, vertical faucet or washing
machine.
• Make sure all hose connections are tight.
Note:
The end of the drain hose mustn't
be submerged in water for the washer to
operate properly.
USING THE APPLIANCE
This appliance has been designed
exclusively for domestic use.
• Never use the appliance for anything
adapter
into
tighten
the
screws
the
adapter.
kink
the
the
hose.
Publicidad
