Publicidad
Idiomas disponibles
Idiomas disponibles
"Adjusting and Leveling the Feet"
section).
• Do not install on a carpet or similar
surface.
• Enviroment cleaning: It is necessary to
clean the wall, door and floor. Install the
washing machine on a stable floor with
a drain nearby. Do not place laundry
or other items on top of the washing
machine; otherwise, it may affect the
machine's functionality.
• Environmental Climatic Conditions:
• Do not place the washer where
the temperature is below freezing.
The pipes will freeze and break.
Subzero
temperatures
damage the programming controller.
Avoid direct sunlight.
• Make sure it is located in a place with
adequate ventilation.
• The ambient temperature should be
between 0 - 40ºC.
• Ambient humidity should be less than
95% (at a temperature of 25°C).
• Keep the washer away from sources
of heat.
• Do not place the washer on the power
cord.
• Electrical outlet: The distance between
each side of the washer and the
electrical outlet should be 1.5 meters. Do
not plug too many appliances into one
outlet.
• Electrical Connection:
• Since the maximum current flowing
through the appliance is 10 A when
using its heating function, make sure
that the electrical system (current,
voltage and wiring) in your home can
support normal load requirements.
• Do not use the junction box or similar.
• If the cables are damaged, contact an
electrician for immediate repair.
• After use, unplug the washer and turn
off the water.
• Connect the washer to a grounded
outlet.
• Install the washer so that it can be
easily plugged into the outlet.
• Contact the service center and have
the washer repaired by a professional.
• Grounding Introduction: A washing
machine
grounding devices. If any problems
arise, this device can reduce the risk of
electrical shock. The device is equipped
with a wire that includes a grounded
plug. If you want to know if your
washing machine is properly grounded,
contact your service personnel. If your
washing machine emits smoke or an
unusual odor, cut the power and contact
professional maintenance staff.
• Water: Washing machines must have a
water inlet. To ensure proper operation,
water injection tests are performed
will
also
before the washing machine leaves the
factory, so there may be water inside
the drum.
Adjusting and Leveling the Feet:
To reduce noise and vibration, level the
washer. If the floor is uneven, level the
washer using the adjustable feet. Do not
place pieces of wood or similar objects.
Make sure that all four feet touch the floor
firmly and that the washer is completely
level.
Note: Adjust the adjustable feet to ensure
the washer is balanced. After they are
properly positioned, screw them in place
for added security. Do not place the washer
on a platform higher than the floor to
prevent the machine from falling.
15. Locking nut
16. Support leg (Rubber cover)
How to o adjust the feet (see Figure 05 on
page 5):
• When setting up the machine, check
that the feet of the washer are in the
factory position. If not, return them
to the factory position: The jam nut is
tightened on the bottom of the washer
body and the support foot is tightened
on the jam nut. (Fig. 1) Note: For ease of
installation, the feet may not be locked
at the factory. Be sure to lock all four
feet before adjusting the level.
• Once the washer is in place and the feet
must
be
connected
EN
to
77
Publicidad
