SICK WLD4F 30 00 Serie Instrucciones De Uso página 32

OPERATING INSTRUCTIONS
en
6.3.1 Configuration via IO-Link
6.4 Process data structure
32 O P E R A T I N G I N S T R U C T I O N S | WLD4F
The sensing range is adjusted by pressing the teach-in button (approx. 1-3 sec.).
WLD4Fx-xxxxxx30
1...3 sec.
NOTE
Do not operate the teach-in button using sharp objects.
Please refer to the enclosed operating instructions for the IO-Link photoelectric sensor
for information about adjusting the IO-Link sensing range.
The sensor is adjusted and ready for operation.
WLD4FP-xxxxxx00A00 / WLD4FP-xxxxxxA0Zxx:
Sensor which it is not possible to set: the sensor is adjusted and ready for operation.
In addition to manual setting the parameters on the device, the sensor can also be
configured via IO-Link.
Configuration via IO-Link can be performed in two ways:
• Configuration via the SiLink box (required software: SOPAS ET from SICK)
To do this, connect the sensor to a computer via USB using the SiLink box.
• Configuration via an IO-Link Master (PLC), e.g. SIG350
You can quickly and easily test and parameterize the connected products using the
SOPAS ET program (SICK Engineering Tool with graphic user navigation and convenient
visualization).
Details on configuration can be found in the detailed IO-Link description:
Information: Photoelectric sensors, SICK Smart Sensors /
WLD4FP-xxxxxxxxAxx:
Technical
IO-Link.
8025303.1N1Y/2024-03-11 | SICK
Subject to change without notice