Microlife OXY200 Manual Del Usuario página 7

8. Malfunctions and actions to take
Description Symptom/
Possible causes
SpO or pulse 1. Finger is not
2
inserted
rate do not display
correctly.
normally.
2. Patient SpO
value is too
low to be
measured.
3. There is
excessive illu-
mination.
SpO or pulse 1. Finger might
2
not be inserted
rate is shown
deep enough.
unstable.
2. Excessive
patient move-
ment.
Microlife OXY 200
Description
Solutions
The device cannot
be powered on.
1. Retry
inserting the
finger.
2. & 3.
2
Measure
more times.
If you deter-
mine the
product is
working
The display
correctly,
suddenly switches
consult your
off.
doctor.
1. Retry
inserting the
finger.
2. Sit calmly
and retry.
Symptom/ Solutions
Possible causes
1. No batteries or 1. Replace the
low battery batteries.
power. 2. Remove
2. Batteries are and rein-
not installed stall the
correctly. batteries.
3. The device 3. Contact
may be your local
damaged. Microlife-
Customer
Service.
1. The device is 1. Normal.
automatically 2. Replace the
powered off, batteries.
when no
signal was
detected after
10 seconds.
2. The battery
power is too
low to operate.
9. Cleaning and disinfecting
Use an alcohol swab or cotton tissue moistened with
alcohol (70% Isopropyl) to clean the silicone that touches
the finger inside of the device. Also clean the finger being
tested using alcohol before and after each test. Allow the
device to dry thoroughly before use.
Never use abrasive cleaning agents, thinners or
benzene for cleaning and never immerse the
device in water or other cleaning liquids.
10. Guarantee
This device is covered by a 2 year guarantee from the date
of purchase. During this guarantee period, at our discre-
tion, Microlife will repair or replace the defective product
free of charge.
Opening or altering the device invalidates the guarantee.
The following items are excluded from the guarantee:
 Transport costs and risks of transport.
 Damage caused by incorrect application or non-
compliance with the instructions for use.
 Damage caused by leaking batteries.
 Damage caused by accident or misuse.
 Packaging/storage material and instructions for use.
 Regular checks and maintenance (calibration).
 Accessories and wearing parts: Battery.
5 EN