Functional Description; Putting Into Operation - Abicor Binzel CAT3 Instructivo De Servicio

CAT3

5 Functional description

The holding force of the inserted pressure springs is directly applied to the release flange and
fixes the switching axis, which is positioned by three pins, in the zero position. In the event of
collision, the switching axis tips over, the release flange pushes the spring plate toward the base
of the housing and the trigger is actuated by the spring plate's actuating mechanism. The trigger
is an NC switch. The applied switching voltage is interrupted.
1 3-pole flange plug
Fig. 6 Functional diagram (View from PINs side of the connector)

6 Putting into operation

DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing,
assembly, disassembly and repair work:
• Switch off the power source.
• Close off the compressed air and gas supplies.
• Disconnect all electrical connections.
NOTICE
• Please take note of the following instructions:
 2 Safety on page EN-6
• The system may only be put into operation by qualified personnel
(in Germany see TRBS 1203).
BAL.0324.0 • 2018-06-13
2 Micro switch triggered
5 Functional description
1 GND
2 24 V
Signal
3
3 Micro switch in resting position
EN - 13