Adjusting The Seat - Vermeiren Mercurius 4 LTD Manual De Instrucciones

3.4

Adjusting the seat

L
WARNING: Risk of injury - Never perform adjustments while you are driving.
L
WARNING: Risk of injury - Make sure that the seat is locked securely.
Depth adjustment
Seat height adjustment
The seat can be adjusted in 2 different seat heights (increments: 25 mm).
1. Remove the seat.
2. Remove the bolt  and nut 
3. Move the adjustment bar  upwards/downwards in the receiver , and place these in a
comfortable seat height.
4. Retighten the adjustment bar  with the bolt  and nut .
5. Replace the seat.
6. Check the seat is locked securely.
Remove seat
1. Pull the seat lever upwards.
2. Turn the seat a little bit and lift the seat out the adjustment bar.
3. Release the seat lever
Lock the seat in place
1. Pull the seat lever upwards.
2. Place the seat on the adjustment bar and at the same time
keep the seat lever pressed in.
3. Release the seat lever.
4. Check that the seat is firmly secured.
Swivel seat
1. Pull the seat lever upwards.
2. Turn the seat in the desired direction.
3. Release the seat lever
4. Check that the seat is firmly secured.
1. Pull the seat depth adjustment lever upwards.
2. Move the seat forward or backward over the seat depth rails.
3. To lock the seat in place, let go of the lever once the seat has
reached the desired position.
4. Swivel the seat a little until it locks in position.
5. Check the seat is locked securely.
.
Page 21
Mercurius 4 LTD
.
,
and the seat will always stop after 90°.
1 = Adjustment bar
2 = Washer
3 = Bolt
4 = Washer
5 = Nut
6 = Receiver
2018-09