Quilting Foot - JUKI TL-2200QVP Mini Manual De Instrucciones

Quilting foot

CAUTION:
This quilting foot is convenient for free motion quilting, quilting along with the pattern, free-hand embroidery, etc.
* Do not run the sewing machine idle when the quilting foot is kept at its upper position.
● Front open type
This type is suited for free-motion
quilting. The needle entry point is
easily observed since the front sec-
tion is open.
1/5 inch (5.0 mm)
1/8 inch (3.2 mm)
Plate
Presser
bar
Screw in the presser foot
Turn OFF the power switch when replacing the presser foot.
● 1/5 inch = 5.0 mm type
This type is suited for free-motion
quilting in general.
1/8 inch (3.2 mm)
Needle clamp screw
● 1/4 inch = 6.5 mm type
This type is suited as a guide for
sewing stitches at regular intervals.
1/5 inch (5.0 mm)
1/8 inch (3.2 mm)
1
Turn off power. Install the quilting foot. Put
the plate on the needle clamp screw, insert
the installing portion into the presser bar, and
securely tighten the screw in the presser foot.
2
Position Feed Dog in lower position.
3
Position stitch length adjusting dial "0". Rotate
presser foot pressure regulator until blue bar
in pressure indication window is at top.
4
Lower the foot and start sewing.
1/4 inch (6.5 mm)
29