Abicor Binzel ABIROB A Serie Instructivo De Servicio página 44

11 Disassembly
11 Disassembly
EN - 22
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance,
servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close the compressed air supply.
• Switch off the entire welding system.
• Disconnect the mains plug.
NOTICE
• Disassembly must only be carried out by qualified personnel
(in Germany, see TRBS 1203).
• Please consult the operating instructions for the welding components,
such as the welding power source and the robot control unit.
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-16
1 Disconnect the cable assembly from the wire feeder.
2 Remove the parts to be disconnected (change body, bracket, CAT robot
mount, torch neck).
®
ABIROB A