Attaching The Machine-Side Connector; Connecting The Control Lead - Abicor Binzel ABIROB A Serie Instructivo De Servicio

6 Putting into operation

6.3 Attaching the machine-side connector

6.4 Connecting the control lead

a = green, b = white, c = brown, d = yellow (insulated), e = grey (insulated), f = blue (insulated),
g = pink (insulated), h = black, i = purple, j = red (insulated)
Fig. 6 Connecting the control lead
EN - 14
 Fig. 5 Setting up the cable assembly on page EN-13
Check once again whether the wire guide has been fitted correctly.
1 Join the central connector (4) and the central socket at the wire feeder and
secure them with the connection nut (6).
2 Fasten the air-blast hose (5) to the air-blast and injection unit or the air-blast
valve. Seal the connector gas tight if the 'air blast' option is not used.
 Fig. 5 Setting up the cable assembly on page EN-13
The control lead (3) is open on the machine side. The customer must connect
a suitable plug. If all data are provided, the device can also be delivered ready
for connection. Otherwise, choose a compatible plug for your power source
and solder it to the corresponding leads according to the terminal diagram.
GN
WH
BN
YE
GY
BU
PK
BK
VT
RD
®
ABIROB A
a
b
c
d
e
f
g
h
i
j