Control Panel - Schumacher Electric CR1 Manual Del Usuario

5. ASSEMBLY INSTRUCTIONS
Remove all cord wraps and uncoil the cables prior to using the battery charger.
6.

CONTROL PANEL

LED Display
A.C. POWER
There is AC power supplied to the battery charger.
CHARGING
The charger is charging the battery.
CHARGING
The charger is in abort mode.
CHARGED
The battery is fully charged and the charger is in maintain mode.
CHARGED
The battery is 80% charged and is ready to use.
7. OPERATING INSTRUCTIONS
Battery Information
This charger can be used with 6 and 12V batteries; it automatically detects your battery type.
Charging
NOTE: Examine the battery for excessive wear, cracks, bulging or damage each time you
charge it. If damage is detected, do not charge the battery; replace it immediately. If the
battery is hot, allow it to cool before charging.
1. Select the proper output cable by matching the output cable connector to the vehicle's
battery connector.
2. Connect the battery following the connection instructions described in Using the Quick-
Disconnect Cable Connectors section.
3. Connect the AC power following the precautions listed in section 3.
4. If you've connected everything correctly, the CHARGING
indicating that the charger is charging.
not supply current to the battery clips until a battery is properly connected. The clips will
not spark if touched together.
Using the Quick-Disconnect Cable Connectors
1. Connect the output cable assembly to the charger. Make sure to place the charger on
a dry, non-flammable surface, such as metal or concrete.
2. With the charger disconnected from the wall outlet, connect the supplied harness
assembly by connecting the blue connector to the blue connector on the end of the
charger cable. Connect the other end of the cable assembly to the battery.
NOTE: See Replacement Parts for more connector information.
NOTE: Never connect the output cable assemblies together for use in other applications,
such as external battery or other power source charging, or to extend the output cable
length, as reverse polarity and/or overcharge conditions will occur.
Quick Charge
When the CHARGED
charger from the wall outlet and then disconnect the charger from the battery. NOTE: The
CHARGING
Complete Charge
When the CHARGED
turns off, the battery is completely charged and the charger has stopped charging and
switched to the Maintain Mode of operation. When ready to use, unplug the charger from
the wall outlet and then disconnect the charger from the battery.
(red) LED lit:
(yellow) LED lit:
(yellow) LED flashing:
(green) LED lit:
(green) LED flashing:
This battery charger must be properly assembled in accordance with the
assembly instructions before it is used.
This charger does not have an ON/OFF switch. ON and OFF are
controlled by plugging in the charger to the AC wall outlet. The charger will
LED begins to flash, the battery is ready to use. Unplug the
LED will remain lit while the CHARGED
LED stops flashing and stays lit and the CHARGING
4
• •
LED should be lit,
LED is flashing.
LED