To
1)
Pause
Remove the MD
1)
The REC indicator flashes during recording pause. Track marks are not added while recording with
microphones, even when the recorder is paused.
If the recording does not start
• Make sure the recorder is not locked (pages 9
and 41).
• Make sure the MD is not record-protected
(page 54).
• Premastered MDs cannot be recorded over.
Notes
• For long recordings, it is recommended that
you power the recorder from a house current
using an optional AC power adaptor AC-
E30HG (page 43).
• Do not connect an optional AC power adaptor
during a recording operation if you are
operating the recorder on battery power. If you
do, the material recorded up to that point will
not be saved to the disc
• The lid will not open during recording or until
"TOC Edit" disappears from the display after
the recording has completed.
• If the power supply is disrupted (i.e. the
batteries are removed or becomes exhausted
or the optional AC power adaptor is
disconnected) during a recording operation, or
while "TOC Edit" appears in the display, then
it will not be possible to open the lid until
power is restored.
• "Data Save" or "TOC Edit" flashes while data
of the recording (the track's start and end
points, etc.) is being recorded. Do not move or
jog the recorder or disconnect the power
source while the indication is flashing in the
display. If you do, the material recorded up to
that point will not be saved to the disc.
• When you record through the microphones,
the various sounds made by the recorder may
also be recorded.
• The built-in microphones do not operate
whenever an optional microphone is
connected into the MIC (PLUG IN POWER)
jack on the recorder.
Operation
Press XPAUSE while recording.
Press XPAUSE again to resume recording.
xSTOP to stop recording and open the lid. (Be sure
that "TOC Edit" has disappeared from the display
before opening the lid.)
• The built-in microphones do not operate
whenever an optical cable or a line cable is
connected into the LINE IN (OPTICAL) jack
on the recorder.
13
-GB