Cautions On Use; About Condensation - Pioneer XW-NAV1-K Manual De Instrucciones

13 Additional information

Cautions on use

When moving this unit
When moving this unit, check first that there is
no disc loaded and disconnect the iPod/
iPhone. Then press  STANDBY/ON on this
unit (or  STANDBY/ON on the remote
control), wait for the OFF indicator on the front
panel display to turn off, then unplug the power
cord. Damage may occur if the unit is
transported or moved with a disc inserted, or
when another device is connected to the iPod/
iPhone connector port, USB terminal, or AUX
IN mini-plug jack.
Place of installation
• Choose a stable place near the TV or stereo
system being used with this unit.
• Do not place this unit on top of a TV or color
monitor. Also install it away from cassette
decks and other devices easily affected by
magnetic forces.
Avoid the following types of places:
• Places exposed to direct sunlight
• Humid or poorly ventilated places
• Extremely hot places
• Places exposed to vibrations
• Places in which there is much dust or
cigarette smoke
• Places exposed to soot, steam or heat
(kitchens, etc.)
Do not place objects on this unit.
Do not place any objects on top of this unit.
Do not obstruct the ventilation holes.
Do not use this unit on shaggy rugs, beds,
sofas, etc., or wrapped in cloth, etc. Doing so
will prevent the heat from dispersing, leading
to damage.
40
En
Do not expose to heat.
Do not place this unit on top of an amplifier or
other component that generates heat. When
placing it in a rack, to avoid the heat given off
by the amplifier or other audio component,
place it on a shelf below the amplifier.
• Turn off the unit's power when not using it.
• Depending on signal conditions, striped
patterns may appear on a TV screen and
noise may enter the sound of radio
broadcasts when the unit's power is on. If
this happens, turn the unit's power off.

About condensation

If this unit is moved suddenly from a cold place
into a warm room (in winter, for example) or if
the temperature in the room in which this unit
is installed rises suddenly due to a heater, etc.,
water droplets (condensation) may form inside
(on operating parts and the lens). When
condensation is present, this unit will not
operate properly and playback is not possible.
Let this unit stand at room temperature for 1 or
2 hours with the power turned on (the time
depends on the extent of condensation). The
water droplets will dissipate and playback will
become possible. Condensation can also
occur in the summer if this unit is exposed to
the direct wind from an air-conditioner. If this
happens, move this unit to a different place.
Cleaning the product
• Unplug the power cord from the power
outlet when cleaning this unit.
• Clean this unit using a soft cloth. For tough
dirt, apply some neutral detergent diluted
in 5 to 6 parts water to a soft cloth, wring
out thoroughly, wipe off the dirt, then wipe
again with a soft, dry cloth.
• Alcohol, thinner, benzene, insecticides,
etc., could cause the print or paint to peel
off. Also, leaving rubber or vinyl products in
contact with this unit for long periods of
time could mar the cabinet.