Setting The Tv System; Cautions On Use - Pioneer X-SMC5-K Manual De Instrucciones

Additional information

Setting the TV system

• This setting is available for a disc content. For iPod/
iPhone's TV out setting, operate your iPod/iPhone.
• If the picture of the disc being played is distorted, switch
the TV system to the one used in your country or region.
• When the TV system is switched, the types of discs that
can be played are limited.
• The factory default setting is AUTO.
Press  STANDBY/ON to turn the unit's
1
power off.
Press  STANDBY/ON while pressing
2
VOLUME +.
Use the buttons on the unit's top panel.
The power turns on and the TV system switches as shown
below.
• AUTO  NTSC
• NTSC  PAL
• PAL  AUTO
Types of Format
discs/files
NTSC
NTSC NTSC
PAL NTSC
-
NTSC
no disc

Cautions on use

When moving this unit
When moving this unit, be sure to first that there is no disc
loaded and disconnect the iPod/iPhone, USB storage device,
LAN cable or any other equipment connected to the unit.
Then press STANDBY/ON on this unit (or STANDBY/ON on
the remote control), wait for the POWER ON indicator on the
front panel display to turn off, then unplug the power cord.
Damage may occur if the unit is transported or moved with a
disc inserted, or when another device is connected to the
iPod/iPhone connector port, USB, LAN (10/100) terminals, or
AUX IN, PHONES mini-plug jacks.
Playing setting
PAL AUTO
PAL NTSC
PAL PAL
PAL NTSC
or PAL
Place of installation
• Choose a stable place near the TV or stereo system being
used with this unit.
• Do not place this unit on top of a TV or color monitor.
Also install it away from cassette decks and other
devices easily affected by magnetic forces.
Avoid the following locations:
• Places exposed to direct sunlight
• Humid or poorly ventilated places
• Extremely hot places
• Places exposed to vibrations
• Places in which there is much dust or cigarette smoke
• Places exposed to soot, steam or heat (kitchens, etc.)
Do not place objects on this unit.
Do not place any objects on top of this unit.
Do not obstruct the ventilation holes.
Do not use this unit on shaggy rugs, beds, sofas, etc., or
wrapped in cloth, etc. Doing so will prevent the heat from
dispersing, leading to damage.
Do not expose to heat.
Do not place this unit on top of an amplifier or other
component that generates heat. When rack mounting it, to
avoid the heat given off by the amplifier or other audio
component, place it on a shelf below the amplifier.
• When not using the unit, set Quick Start Mode to Off,
then turn off the unit's main power.
• Depending on signal conditions, striped patterns may
appear on a TV screen and noise may enter the sound of
radio broadcasts when the unit's power is on. In this
event, set Quick Start Mode to Off, then turn off the
unit's main power.
About condensation
If this unit is moved suddenly from a cold place into a warm room
(in winter, for example) or if the temperature in the room in which
this unit is installed rises suddenly due to heater operation, etc.,
water droplets (condensation) may form inside (on operating
parts and the lens). When condensation is present, this unit will
not operate properly and playback is not possible. Let this unit
stand at room temperature for 1 or 2 hours with the power turned
on (the time depends on the extent of condensation). The water
droplets will dissipate and playback will become possible.
Condensation can also occur in the summer if this unit is directly
exposed to the air flow from an air-conditioner. If this happens,
move this unit to a different place.
15
51
En