PRESIDENT LINCOLN I Manual Del Usuario página 8

A "Beep" sounds each time the channel/frequency changes if the BEEP
function is activated (see KEY BEEP function page 9).
In status, the s/t keys allows to
MENU
11) LCD
Indicates transmission
Indicates that front panel keys are locked except PTT pedal
and knobs. LCD shows "Err" when locked key is pressed
Beep function activated
on TX, bargraph shows Standing Wave Ratio (SWR) and value
(see INDIC function following)
ROGER ROGER BEEP function is activated
ECHO ECHO function is activated
DW
DUAL WATCH activated
10K Frequency +10K function is activated
NB NB filter activated
ANL
ANL filter activated
HI-CUT HI-CUT filter activated
EMG The emergency channel 9 or 19 activated
SCAN
SCAN function activated
Automatic Squelch Control activated
VOX VOX function activated
MEM
Memorised frequency is selected
DCS DCS code is used
CTCSS CTCSS tone is used
AM
AM mode selected
FM FM mode selected
select menu.
USB USB mode selected
LSB
LSB mode selected
CW CW mode selected
PA PA (Public Address) mode selected
Shows the channel number
Shows the current Band
Shows DCS code or CTCSS tone
Shows the frequency and menu values
12) INDIC ~ CALL
INDIC
(short press)
Press INDIC key (12) to display
Press INDIC key (12) again or wait for 5 seconds to
In TX, press INDIC key (12) to
nates with: FREQUENCY ~ SWR ~ TOT ~ VOLTAGE. Every time the PTT pedal is
pressed, LCD shows frequency and selected feature.
CALL
(long press)
Press INDIC-CALL key (12) every time to
calling. LCD shows "TX". (see § CALL FREQUENCY, page ).
13) ECHO ~ ECHO SET
ECHO
(short press)
Press ECHO key (13) to enable/disable
ECHO SET
(long press)
Press ECHO-ECHO SET key (13) to
"ECHO" blinks on the LCD.
Press s/t keys (10) on the unit or on the microphone (24) to
" " or " " on the menu list.
Ratate PUSH knob (6) to set
the selected feature. There are 32 DELAY levels,
default: 10. There are 32 "TIME", default: 1. LCD shows selected "
level or selected " ".
Press MEM-STORE (5) key for 2 seconds to
Wait for 5 seconds to exit ECHO SET.
14) CH9/19 ~ LOCK
CH9/19
(short press)
8
current voltage, shows as "13. 8 DC"in LCD.
disable voltage display.
select
the feature to be displayed. LCD alter-
send
pre-edi ting prompt voice code
ECHO function. LCD shows "ECHO".
set ECHO VOLUME level and ECHO TIME.
select
store and skip into next menu.
alternately
"