General Characteristics Of The Operator; Main Operator Parts - Erreka TOPO Manual Del Instalador

DESCRIPTION OF THE PRODUCT
2

GENERAL CHARACTERISTICS OF THE OPERATOR

The TOPO operator is constructed to form part of a
swing gate automation system, also replacing the lower
hinge of the gate.
It comprises a galvanised steel base box, buried
underneath the gate, which contains the motor and the
operation mechanism. Allows a maximum opening of
110º (or 180º with the NBKIT-180 kit).
This operator, along with its corresponding Erreka
control panel, allow the implementation of a soft stop
system, with the speed slowing down at the end of the
closing and opening operations.
3

MAIN OPERATOR PARTS

Fig. 2 Main parts
44
Installation manual
The motor is irreversible, thus guaranteeing the
mechanical locking of the gate. However, for leaf
lengths of over 2.5m we recommend using an
electrolock.
The operator has an unlocking mechanism in order to
operate the gate manually in the event of failure of the
electricity supply.
This operator allows us to fulfil the requirements of
standard EN 12453 without the use of peripheral
elements.
Components:
1 Galvanised steel base box
2 Orifice for electrical duct
3 Orifice for drainage
4 Motor gear box
5 Motor arm
6 Intermediate arm
7 Driven arm (lower)
8 Driven arm (upper)
9 Unlocking mechanism
10 Mechanical stop in opening
11 Mechanical stop in closing
12 Lubricator
Cabling:
• Red and blue cables: motor
• Brown cable: encoder power supply (V+)
• Green cable: encoder signal (SNG1)
• Mesh: encoder mass (GND)