Chapter 9 - Accessory; Chapter 10 - Warranty - Wolf Garten Robo Scooter 500 Instrucciones De Servicio Originales

Problem Encountered Probable Cause/Event
The Robomow is noisy
• Damaged or unbalanced blade
and vibrates
• Grass is too high in relation to the set cutting height
Poor quality of mowing
(grass clippings are left
• Grass is wet
on the lawn) or Uneven
mowing results • Dull blade
• Robo Scooter 500 works too few operations per week
• Working area is too large
LCD display is in a for- • The language setting was changed or not correctly
eign language.
• Battery is not fully charged at the beginning of the ope-
Short run time, operates
less time than normal
• 'Work Time ' for that zone is set to specific time and
3
Note
It is possible to
see the last 10
battery run times
and the battery
voltage at the be-
• Grass is extremely over grown or very wet.
ginning of the ope-
ration in the
'Information' menu
• Batteries are reaching a normal end of life state.

Chapter 9 - Accessory

Item number
1011-RM-0500
196-798-678
196-797-678
196-795-678
196-796-678

Chapter 10 - Warranty

The warranty rules issued by our company or the importer apply to
every country. As part of the warranty, we remedy malfunctions on
your appliance free of charge provided that this malfunction is caused
by a material or manufacturing defect. In the event of a warranty
claim, please turn to your dealer or the nearest branch office.
en
set.
ration
not to 'MAX'
Order description
Blade
Peg Pack (50 pieces)
Perimeter Wire
Perimeter Switch
Batteries Pack for Perimeter Switch
Corrective/User Action
• Check the lawn is free from branches, stones or other
objects that can damage the blade before operating
the Robomow.
• Replace the blade
• It is recommended to cut not more than a 1/3 of the
green part of the grass.
• Set the cutting height to a higher position
• Use Robomow more frequently to maintain your lawn.
• For best cut, operate Robomow when the grass is dry.
It is recommended to mow grass early afternoon.
• Replace blade.
• Update the weekly program for more operations per
week.
• Limit the working area
• Place the mower out of the Base Station and follow the
sequence listed;
1. Press 'STOP' button few times to confirm it is on the
main display
2. Press 'UP' ? button twice
3. Press 'Down' arrow button once
4. Press 'GO' button once
5. Press 'Down' arrow button 4 times
6. Press 'GO' button once
7. Using the arrow, scroll to the correct language
8. Press 'GO' to confirm this selection
• Confirm the battery icon is fully and not changed
(while charging in the Base Station) or 'Ready keep
charging' message is displayed (while charging
through power supply) prior the operation.
• 'Work time' can be changed under 'Zones setup' menu
• Raise cutting height.
• Always mow the grass frequently enough to prevent
over growth.
1
Warning!
Remove battery fuse before lifting the mower
• Inspect blades for foreign material or debris preven-
ting rotation.
• Clean out accumulated grass clippings using a woo-
den stick.
• Replace batteries.
Item number
196-804-678
5031-RM-0010
196-799-678
5031-RM-0500
Order description
Remote Control
Wire connector
Plot connector
2 x 12 AH Batteries
55