TOHATSU MD 30B2 Manual Del Propietário página 40

38
PRE-OPERATING PREPARATIONS
ENOW00022-0
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before starting engine. (To
properly fill the engine with oil follow the
instructions in section 10 of this manual)
ENON00007-0
Note
Use of engine oils that do not meet these
requirements will result in reduced engine
life, and other engine problems.
ENOW00604-0
6
In the unlikely event that gasoline by
mistake is filled into the oil tank, drain
the oil tank completely, and consult an
authorized service shop for advice.
Check the amount of oil in the oil tank
visually before starting the engine. Run-
ning out of oil at sea is a cause for
potential disaster.
The required amount of engine oil is auto-
matically supplied from the oil tank,
through the oil pump, according to the
engine running conditions. Gasoline is fed
over a separate feeding line.
ENOM00644-1
Replenishing oil in the engine oil tank.
1. Open the filler lid from the top cowl.
2. Open the oil tank cap.
3. Fill the oil tank with the genuine engine
oil.
4. After replenishment of the oil tank, be
sure to close the oil tank cap tightly.
CAUTION
CAUTION
ENOM00645-0
Oil pump air vent
Visually check whether there is air in the oil
through the vinyl pipe connecting the oil
tank with the oil pump. If present, Purge
the air as follows:
30, 40, 50
Loosen the air vent screw on the oil pump
to purge the air, and tighten it when all air,
as seen through the vinyl pipe on the oil
pump side, has been purged.
30, 40, 50
1
2
3
1. Air vent screw
2. From oil filter
3. Vinyl pipe
75, 90, 115
See page 40 for air removal from the oil
lines.
ENON00608-0
Note
Wipe off any spilled oil with a rag, and dis-
pose of it.
ENOF00642-0