TOHATSU MD 30B2 Manual Del Propietário página 44

42
PRE-OPERATING PREPARATIONS
Remedy
1.
Reduce the throttle to less than half
opening, and move to safe place
quickly, and stop the engine.
Check the propeller for bent or dam-
aged blades.
Consult an authorized dealer if engine
shows the same result even after
replacing propeller with new one.
2.
Move to safe place quickly, and stop
the engine.
Check the engine oil level, and add
engine oil if necessary.
3. Move to safe place quickly, and check
the discharge of cooling water from the
6
water check port at idle speed and
stop engine.
Remove any foreign matter on the gear
case and propeller if necessary. Con-
sult an authorized dealer if no dis-
charge of cooling water.
4.
Charge or replace the battery.
5.
Consult an authorized dealer.
ENOW00025-A
Low speed ESG ON: Engine speed will
be limited to 3000 rpm, however you
should not continue to run engine.
High speed ESG ON: Engine speed will
be limited to 6000 rpm and engine will
run rough until throttle is reduced.
CAUTION